PRESSURIZED SYSTEMS

This system is used on residential units using pressure pumps, similar to the Non-Pressurized system; it relies on the “THERMO-SIPHON” principle.
The storage cylinder (the tank) is always located higher than the collector.

It is a Closed Circuit, where the heated water remains in the tank.
The state water supply enters directly into the inlet water hole through an efficient 8-bar pressurized copper coil heat exchanger located inside the tank, gains heat and comes out from the hot water outlet hole.

This system uses TECHNO-SOLAR M SERIES all glass vacuum tubes as heat collectors, the cylinder (tank) is made of argon welded stainless steel sheet (SUS 316 LOW CARBON) and the best insulation performance is ensured by high-density polyurethane integer foam made under high pressure and constant temperature conditions.

TECHNICAL DATA